Silverline 394970 - Troubleshooting

EN
12
Problem Possible Cause Solution
Tooloperatingslowly
Pressure incorrect Setthecorrectairpressureaccordingtothespecication
Dirtwithinthemechanism PouroilintoAirInlet(4)aspermaintenanceinstructions
Air blockage Operatetoolinshortburststoclearblockage
Air leak
Checkallttingsandhoseforairleaksandcorrectissuebyre-
tightening,usingPTFEtapeorreplacing
Blockageingauzemeshlter RemoveQuickConnector(5)andcleanmeshlter
Tool seized
Dirt or rust in mechanism Try‘Tooloperatingslowly’solutions
Dirt or rust in mechanism Taptoolgentlywithasoftmallet
Toolwillnotstopaftertriggeris
fully released
ThrottlevalveO-ringorvalveseatdamaged Have the tool repaired at an authorised Silverline service centre
If the above troubleshooting solutions fail, contact your dealer or an authorised Silverline service centre.
Troubleshooting
394970_OwnerManual.indd 12394970_OwnerManual.indd 12 02/05/2024 08:3502/05/2024 08:35