31
IQ POWER CONTROL STATION
WITH SENSOR TECHNOLOGY
5201263 Rev D
Icon typically used for an IQ Power Fantom wide blower paired with
an IQ Easy Sensor Bar.
The icons will display with a background color that corresponds to the device status:
Gray - inactivity
No device shown - no device was found at the address
Neutralizer shown - HV is turned off / standby mode
Green - normal operating status
Yellow - warning status:
Neutralizer - cleaning is needed
Sensor - voltage detected over warning setpoint
Red - alarm status
Neutralizer - fault alarm / communication failure
Sensor - voltage detected over alarm setpoint / fault alarm / communication
failure
If an IQ Easy device that is not compatible is plugged into the system the device icon
will be red and bear the message “Upgrade Required”. The device will be powered
and operating in a stand-alone mode. Upgrading a device is available at the factory,
contact Simco-Ion customer service at (800) 203-3419.
The Device Page for a static neutralizer will open to a Summary tab highlighting
a variety of information about the neutralizing equipment. Information is not
editable from the summary tab.
Typical Summary Tab
• Device Name
• Ion Output
• Operating Mode
• Ion Current
• Balance
• Web Speed
• Overall Sensor Average (if paired)
• Mounting Distance (Auto-Tune)
• Feedback Sensor Average (if paired)
• Sensors for Feedback (if paired)
The Device Page for a static neutralizer includes tabs for the Neutralizer and Sensor
(if paired). These tabs typically offer more detailed information and the ability to
edit or make adjustments to settings. Neutralizer and sensor tabs typically contain
more than one page, the pages being accessed by tapping the arrow head of “Page
x/x” in the upper right of the display.
To Next Page
Loading...