Need help?Do you have a question about the Sime AR Series and is the answer not in the manual?
General| Model Series | AR Series |
|---|---|
| Category | Boiler |
| Manufacturer | Sime |
| Modulation | Yes |
| Modulation Range | 1:5 |
| Heat Exchanger Material | Stainless Steel |
| Fuel Type | Natural Gas or LPG |
| Weight | 32 kg |
| Dimensions (HxWxD) | 700x400x280 mm |
Overview of the 'AR ARB freestanding' series boilers, their compliance with directives, and their function.
Provides detailed dimensions and diagrams for 'AR' and 'ARB' models, listing measurements for various components.
Presents a comprehensive table of technical specifications for AR3, AR4, AR5, ARB4, and ARB5 models.
Illustrates the operational diagram for the 'ARB' model, with a key identifying system components.
Details the dimensions of the combustion chamber and the refractory brick used in 'AR' and 'ARB' series boilers.
Outlines the requirements for the boiler room, adhering to standards for liquid fuel heating systems.
Specifies clearances required around the boiler body and ceiling height for the installation room.
Explains the connection of the heating system, including safety accessories and filling procedures for 'ARB' models.
Details the importance and requirements of the flue system for proper boiler operation, including material and dimension specifications.
Provides step-by-step instructions for fitting the casing and control panel to the 'AR' model, referencing figure 5.
Describes the electrical connections required for the boiler, including power supply and room thermostat installation.
Lists essential checks to perform before the initial start-up of the boiler to ensure correct operation.
Guides on how to light and operate both 'AR' and 'ARB' boiler models, including thermostat settings and mode selection.
Provides step-by-step instructions for disassembling the casing of the 'ARB' boiler model, referencing figure 8.
Explains the function of the magnesium anode in protecting the boiler and the importance of its periodic check and replacement.
Recommends cleaning the boiler body and flue at the end of each season, mentioning baffle removal and pipe cleaning.
Advises to turn off the equipment if faults occur and to contact authorized personnel for any operation.
To Next Page
