Sime HOME PLUS - Fault Warnings

24
EN
– Press the encoder
clic
k
to confirm the modification and
move to the next
“data/value”
Cancel Confirm
HOLIDAY SCHEDULE
Hot water OFF - Heat. OFF (nofrost active)
DAY MONTH YEAR HOUR
Start: 05 02 2014 15 : 00
20 02 2014 15 : 00
Stop:
Enable holiday: NO
0
5
– Rotate the encoder to modify the “data/value" on the
basis of the holiday start date
– Press the encoder
clic
k
to confirm the modification and
move to the next
“data/value”
– Continue in this way until all the necessary modifications
have been made
NB: The user must work in a CIRCULAR manner ("rounda-
bout") therefore, ALWAYS MOVING FORWARDS, even if a mis-
take has been made.
– When all modifications have been made, press the button
Confirm
to go back to the item “Holiday function”
– Press the button
Esc
to go back to the “main screen” .
Th 21 Sept 2014Zone 10:30
Menu Mode
Hot water 48°C eco
Winter automatic - set 20.0°C until 7.30
4.3.3 Fault warnings
If a fault occurs, the screen “Anomaly in progress” will ap-
pear in place of the “main screen”.
For the main fault codes, a brief description and suggestions
for the user are displayed based on the seriousness and the
frequency with which the fault reappears.
Es
cB
ack
ANOMALY IN PROGRESS
5 - Technical problem
Contact customer service
Name: xxxxxxxx
Phone:yyyyyyyyy
Es
cR
eset
ANOMALY IN PROGRESS
6 - No flame detection
Reset boiler
The fault maybe a transient (volatile) fault or a fault which
blocks the appliance.
To restore normal operating conditions:
– if the fault is transient, eliminate the cause of the fault
– if the fault causes a block, eliminate the cause of the fault
and then press the button
Reset
.
If there is
no water in the system or low water pressure in the
system
there will be a request to fill the system and then press
the button
Confirm
rather than
Reset
.
Cancel Confirm
CONFIRM REQUEST
Confirm operation?
Es
cC
harge
ANOMALY IN PROGRESS
2 - Low pressure
Fill the system as per boiler's manual instruction