14
4.7. Placing and Securing of the Oven
Place the oven to the cabinet with two or more persons.
Make sure that the frame of the oven and the front of the furniture
are properly aligned.
The supply cord shall not be left under the oven or be stuck or bent
between the oven and the furniture.
Secure the oven to the furniture using the screws supplied with the
appliance. Screws shall be installed by putting them through the plastics
attached on the frame of the appliance as shown in Fig. 5. The screws
shall not be tightened too much. Otherwise, the screw holes may wear
out.
Check that the oven does not move after installation. If the oven has
not been installed in accordance with the installation instructions, there
is a risk of overturning during operation.
4.8. Electrical Connection
The place where the product shall be installed shall have proper
electrical installation.
The mains voltage shall comply with the rating given on the product
type plate.
Connection of appliance shall be made in accordance with local and
national electrical regulations.
Disconnect the mains power before starting to install the product. Do
not connect the product to the mains until the installation is nished.
4.9. Assembly
GB
To Next Page
Loading...
