Simoniz 039-8702-2 - Shutting Down and Cleaning Up; Taking Breaks During Operation; Chemical Use Warnings

13
6. operatIng InstructIons (cont.)
6.2 Shutting Down and Cleaning Up
a
Turn o water supply and disconnect the garden hose
from the water inlet on the pressure washer.
s
Pull the trigger to release any remaining water pressure.
d
Set the ON/OFF switch to the OFF (O) position.
f
Unplug the power cord from the outlet.
g
Engage the safety lock on the spray gun.
WARNING
Turn o the water supply and pull the trigger to depressurize
the device. Failure to do so might result in personal injury due
to discharge of high-pressure water.
6.3 Taking Breaks
If taking a break while using the pressure washer:
a
Engage the safety lock on the the spray gun.
s
Set the ON/OFF switch to the OFF (O) position.
d
Unplug the power cord from the outlet.
6.4 Warnings
CAUTION
Failure to clean foam blaster properly will cause the detegent
injection system to become clogged and inoperable.
WARNING
Never use:
• Bleach, chlorine products or other corrosive chemicals;
• Liquids containing solvents (i.e., paint thinners, gasoline,
oils, etc.);
• Tri-sodium phosphate products;
• Ammonia products; or
• Acid-based products.
These chemicals will harm the unit and will damage the
surface being cleaned.
Operating Instructions