Simoniz 039-8702-2 - Cleaning and Maintenance; Connection Maintenance; Nozzle Cleaning; Water Filter Screen Maintenance

15
Cleaning and Maintenance / Technical Specications
8. cleanIng and maIntenance
8.1 Connections
The connections on the pressure washer’s hoses, gun, and spray
wand should be cleaned and lubricated with non-water-soluble
grease regularly.
8.2 Cleaning the Nozzles
Clogging of the nozzle causes the pump pressure to be too
high, making it necessary to clean the nozzle immediately. You
can clean the nozzle by carefully inserting the cleaning needle
into the clogged nozzle to clean out any deposits.
8.3 Water Filter Screen
The pressure washer is equipped with a water inlet screen to
protect the pump. If the screen is not kept clean, the ow of
water to the pressure washer will be restricted, and the pump
may become damaged.
To clean the water inlet screen:
• Remove the lter screen from inside the inlet adaptor
(the inlet adaptor comes pre-assembled to the machine).
• Rinse the screen until it is free of debris and obstructions.
• Place the screen back to prevent foreign particles from
entering the pump.
9. technIcal specIfIcatIons
Peak pressure:
2000 PSI
1300 PSI
120 V / 60 Hz
23’ (7 m) 16 AWG
20’ (6 m)
1.5 U.S. GPM (5.7 LPM)
13 A
Cold tap water
Rated max pressure:
Power source requirement:
Electrical cord:
High-pressure hose:
Max ow:
Current drawn:
Inlet water: