7
5. assembly InstructIons
5.1 Water Supply (Cold Water Only)
Only draw water through the unit. The device must be used
with cold water supply only. The water hose must be at least
1/2” (13 mm) in diameter. The water ow rate must not fall below
2 gal/min (9.1 L/min). The ow rate can be determined by running
water for one minute into an empty container. The water supply
temperature must not exceed 40 ºC (104 ºF).
5.2 Safety Advice
CAUTION
• Never use the pressure washer to draw in water
contaminated with solvents (e.g. paint thinners,
gasoline, oil, etc.).
• Dirt in the water inlet will damage the unit. To avoid this
risk, we recommend checking the water lter (located
inside the water inlet). To clean it out, refer to the
Cleaning and Maintenance section.
• Always prevent debris from being drawn into the unit by
using a clean water source and an additional accessory
water lter, if required.
• To prolong the life of the unit, let it rest for 5 minutes
after every 30 minutes of use.
• Check to make sure you have all the parts.
• Remove any objects from the work area that could be a
hazard or tripped over, such as toys or outdoor furniture.
• Ensure that all doors and windows are closed tightly.
5.3 Accessories Storage Locations
a
Assembly Instructions
Cleaning
needle
Cord
hook
Gun and
wand
Foam
blaster
To Next Page
Loading...
