7
Surface Preparation
Before starting any cleaning task, it is important to inspect the area for objects that could
create a hazard. Remove any objects from the work area that could be tripped over, such as
toys or outdoor furniture. Ensure that all doors and windows are closed tightly.
CAUTION
• Never use the pressure washer to draw in water contaminated with solvents (e.g.
paint thinners, gasoline, oil, etc.).
• Dirt in the water inlet will damage the unit. To avoid this risk, we recommend checking
the water
(located inside the water inlet; to clean it out see Maintenance section).
• Always prevent debris from being drawn into the unit by using a clean water source
and an additional accessory water if required.
• To prolong the life of the unit, it is recommended to rest the unit for 5 minutes after
every 30 minutes of use.
Water Supply (Cold Water Only)
Only draw water through the unit. For use with cold water supply only. Water hose must
be at least a 1/2” (13 mm) in diameter. Flow rate of water supply must not fall below 2
GPM (gallons per minute) [9.1 LPM (litres per minute)]. Flow rate can be determined by
running the water for one minute into an empty 5-gallon (19 L) container. The water supply
temperature must not exceed 104°F (40°C).
ASSEMBLY INSTRUCTIONS
1
Attach the left wing (D) and the right wing (J) to the
pressure washer unit.
Attach gun holster.
D
J
2
F
To Next Page
Loading...
