To Next PageTo Next PageHow to fix a Simoniz S1750 Pressure Washer motor that won't start?
If your Simoniz Pressure Washer motor won't start, it could be due to a tripped circuit breaker or blown fuse, a loose plug, or a tripped pressure washer circuit breaker. Try these steps: Disconnect other devices on the same circuit and reset the breaker or replace the fuse. Reconnect the plug securely. Let the unit cool down completely before restarting.
Why Simoniz Pressure Washer motor will not start?
If your Simoniz Pressure Washer motor isn't starting, several factors could be at play. First, ensure the On/Off switch is in the “ON” ( | ) position. Check that the power cord is securely plugged in. If you're using an extension cord, it might be too long, of the wrong gauge, or damaged; try replacing it with a 25’ (7.6 m) or 50’ (15 m) 14/3 gauge cord. The electrical outlet itself may not be providing enough power, so test a different outlet. Finally, the pressure washer's circuit breaker may have tripped; allow the unit to cool down before restarting.
General| Maximum Pressure | 1750 PSI |
|---|---|
| Flow Rate | 1.4 GPM |
| Water Flow | 1.4 GPM |
| Hose Length | 20 ft |
| Engine | N/A (Electric) |
| Nozzles Included | Turbo, 15°, Soap |
