9- ENG
A04196
The nozzle at the end of the
multi-adjustable spray wand can be
rotated to change the high pressure
spray pattern from a 0º pencil stream
to a 40º fan spray, see Fig. 6a and 6b.
Markings have been placed on the
nozzle to help you select the spray
pattern.
For low pressure operation, extend the
nozzle of the multi-adjustable spray
wand as shown in Fig 7.
40º fan spray
0º pencil stream
READ AND UNDERSTAND ALL WARNINGS BEFORE STARTING UNIT
When using the high pressure setting, DO NOT allow the
spray to come in contact with unprotected skin, eyes, or with
any pets or animals. Serious injury can occur.
Your washer operates at fluid pressures and velocities high enough to penetrate
human and animal flesh, which could result in amputation or other serious injury.
Leaks caused by loose fittings or worn or damaged hoses can result in injection
injuries. DO NOT TREAT FLUID INJECTION AS A SIMPLE CUT! See a
physician immediately!
NEVER fill fuel tank when engine is running or hot. Do not
smoke when filling fuel tank.
NEVER fill fuel tank completely. Fill tank to 1/2" below top of tank to provide
space for fuel expansion. Wipe any fuel spillage from engine and equipment
before starting engine.
NEVER run engine indoors or in enclosed, poorly ventilated areas. Engine
exhaust contains carbon monoxide, an odorless and deadly gas.
NEVER
carry pressure washer with engine running, turn engine off and allow it
to cool before carrying pressure washer.
DO NOT
let hoses come in contact with hot engine muffler during or
immediately after use of your pressure washer. Damage to hoses from contact
with hot engine surfaces will NOT be covered by warranty.
NEVER pull water supply hose to move pressure washer. This
could damage hose and/or pump inlet.
DO NOT
use hot water, use cold water only.
NEVER
turn water supply off while pressure washer engine is running or
damage to pump will result.
DO NOT stop spraying water for more than two minutes at a time. Pump
operates in bypass mode when spray gun trigger is not pressed. If pump is left
in bypass mode for more than two minutes internal components of the pump
can be damaged.
If you do not understand these precautions, please call 1-866-293-WASH
(1-866-293-9274) to speak to a service representative for further
instructions.
The powerful spray
from your pressure
washer is capable of causing damage
to surfaces such as wood, glass,
automobile paint, auto striping and
trim, and delicate objects such as
flowers and shrubs. Before spraying,
check the item to be cleaned to
assure yourself that it is strong
enough to resist damage from the
force of the spray.
low pressure
Fig. 6a
Fig. 6b
Fig. 7
To Next Page
Loading...
