11
6. operatIng InstructIons
6.1 Working with the Foam Blaster
Working with a detergent ensures quick soaking of the dirt, and
allows the high-pressure water to penetrate and remove the dirt
more eectively. Always spray detergent on a dry surface, do not
pre-soak the area. Wetting the surface rst dilutes the detergent
and reduces its cleaning ability.
a
Engage the safety lock on the spray gun.
2
1. Detach spray head by turning detergent bottle 1/4 turn
counter-clockwise.
2. Fill the bottle with the detergent.
3. Reattach the spray head on to the bottle by turning 1/4
turn clockwise.
d
1. Attach the foam blaster onto the spray gun.
2. Apply the detergent to a dry work surface from bottom
to top.
3. Allow detergent to remain on the surface for a short
time before rinsing. Do not allow detergent to dry on
the surface.
4. When you are nish working with detergent, ll with
clean water in bottle and spray water for one minute in
ON position to rinse the foam blaster and remove any
soap residues that may clog it.
CAUTION
Damage may occur to painted surfaces if chemicals are
allowed to dry on them. Wash and rinse a small section
at a time.
Operating Instructions
To Next Page
Loading...
