Simoniz XE26 - Shutting down and Cleaning up; Taking Breaks; Warnings

12
6. operatIng InstructIons (cont.)
6.2 Shutting Down and Cleaning Up
a
(Skip this step if you are not using detergent.)
When you nish using the foam blaster, ll the container
with clean water and attach the foam blaster back onto
the spray gun. Spray water for at least one minute (or
until the water is fully depleted from the bottle) in ON
(I) position.
s
Turn o water supply and disconnect the garden hose
from the water inlet on the pressure washer.
d
Pull the trigger to release any remaining water pressure.
f
Set the ON/OFF switch to the OFF (O) position.
g
Unplug the power cord from the outlet.
h
Engage the safety lock on the spray gun.
WARNING
Turn o the water supply and pull the trigger to depressurize
the device. Failure to do so might result in personal injury due
to discharge of high-pressure water.
6.3 Taking Breaks
If taking a break while using the pressure washer:
a
Engage the safety lock on the the spray gun.
s
Set the ON/OFF switch to the OFF (O) position.
d
Unplug the power cord from the outlet.
6.4 Warnings
CAUTION
Failure to clean foam blaster properly will cause the detegent
injection system to become clogged and inoperable.
WARNING
Never use:
• Bleach, chlorine products or other corrosive chemicals;
• Liquids containing solvents (i.e., paint thinners, gasoline,
oils, etc.);
• Tri-sodium phosphate products;
• Ammonia products; or
• Acid-based products.
These chemicals will harm the unit and will damage the
surface being cleaned.
Operating Instructions