10.4 Emergency release active
SmartHandles can be permanently engaged for use automatically using an
automated command from the programming software if a SimonsVoss
network (WaveNet) has been installed. As a general rule, this signal comes
from a fire alarm system and can be interpreted by the LSM (if configured
accordingly). This status can be deactivated again by making an
emergency opening.
10.5 Time-limited opening active
This box is checked in the case of a programmed time switch-over if
automatic time switch-over has engaged SmartHandle.
10.6 Engaged
This box is checked when SmartHandle is engaged for use if a time switch-
over or flip-flop mode is programmed.
SmartHandle (Manual)
10. Status messages
106 / 136
To Next Page
Loading...