Simons Voss Technologies SmartHandle Series - Spindle; Fastening; Backplate Width;Wide; Snap-In

Conventional fastening system SKG:
 S 32 – 50 mm
 M 50 – 70 mm
 L 70 – 90 mm
5.5 Spindle
The following spindle sizes are available:
 7 mm
 8 mm
 F8 (for fire retardant doors)
 8.5 mm
 9mm (for fire retardant doors)
 10 mm
A sleeve is available for the 8.5mm and 10mm solutions. The 10mm
sleeve is part of the supply; order the 8.5mm one if required. See
Accessories to order. The 8mm spindle serves as a basis for the solution;
8mm to 8.5mm and 8mm to 10mm sleeve.
The SmartHandle designs with F8 and 9mm spindles are approved for use
in fire retardant doors:
 F8 (8 mm) spindle as per EN1906 or EN1634
 9 mm spindle as per DIN 18273
5.6 Fastening
Three different types of fastening system available:
 Snap-in
 Conventional fastening system
 Conventional fastening system with MO (blank and cut-out)
Snap-in does not require any additional drill holes in the door as it uses the
existing standard holes for mounting.
With the conventional fastening system, it is possible to also install a
mechanical cylinder to override the electronics.
5.7 Backplate width/wide
The following backplate widths are available for the inlay:
 Narrow plate, 41 mm
 Wide plate, 53 mm
SmartHandle (Manual)
5. Designs
21 / 136