7.4 Conventional fastening system WO
7.4.1 Contents of packaging
2 x inlays
2 x inlay
1 x outer fitting
1 x inside fitting
1 x handle for outer fitting, including lock ring
1 x handle for inside fitting (including hexagon screw)
2 x fastening screws
2 x spacing bolts
1 x quick start guide
1 x installation tool for inlay
7.4.2 Tools required
The following tools are required for installing SmartHandle 3062 and are
not included in the supplied package:
Allen key (3mm) to fit handle
Spanner (19mm)
Cross-tip screwdriver type PH2 (battery screwdriver recommended)
Drill
Drill bits, 8mm and 13mm
7.4.3 Installation instructions MO
Batteries are already installed when the product is delivered!
When installing the electronic SmartHandle 3062, ensure that there are
no sources of low-frequency interference in the surrounding area.
SmartHandle 3062 must be fitted, so that it is flush with the door. You
must install the product as specified to ensure that it is structurally
stable and will have a long service life.
You must not strike parts of SmartHandle 3062 during installation.
The two inlays in the cover are locked into position with a clip
mechanism. These may only be removed using the SimonsVoss
installation tool.
No water or moisture must penetrate the door or reach the inner side.
Always use the WP version for moisture.
SmartHandle (Manual)
7. Installation (manual)
51 / 136
To Next Page
Loading...