EasyManua.ls Logo

Simons Voss Technologies SmartHandle Series - 12 Battery Warning (Manual); Smarthandle G1 Battery Warning (Active); Battery Warning Smarthandle G2 (Active); Battery Warning Smarthandle Hybrid

Simons Voss Technologies SmartHandle Series
136 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12 Battery warning (manual)
12.1 SmartHandle G1 battery warning (active)
Warning level 1
Low batteries --> eight short audible signals before engaging. Batteries
will soon be empty. Replace batteries in the SmartHandle.
Warning level 2
Extremely low batteries --> eight short audible signals 30 seconds long
with one second pause each time before engaging. Batteries are
extremely low. Replace the batteries in the SmartHandle
IMMEDIATELY.
Once Warning Level 2 has been emitted for the first time, the door can
be opened with a transponder a maximum of 50 times.
After reaching this number of opening operations or after about 4
weeks, SmartHandle automatically switches to emergency battery
storage mode. Once at this warning level, SmartHandle can now only
be activated using a SimonsVoss programming device.
Eight short audible signals after disengaging: indicates that the transponder
battery is empty. Transponder battery must be replaced.
12.2 Battery warning SmartHandle G2 (Active)
Warning level 1
Low batteries --> eight short audible signals before engaging. Batteries
will soon be empty. Replace batteries in the SmartHandle.
Warning level 2
Extremely low batteries --> eight short audible signals 30 seconds long
with one second pause each time before engaging. Batteries are
extremely low. Replace the batteries in the SmartHandle
IMMEDIATELY.
Once Warning Level 2 has been emitted for the first time, the door can
be opened with a transponder a maximum of 50 times.
After reaching this number of opening operations or after about 4
weeks, SmartHandle automatically switches to freeze mode. Once at
this warning level, SmartHandle can now only be activated using a
SimonsVoss programming device or using a G2 battery replacement
transponder.
12.3 Battery warning SmartHandle Hybrid
In the case of SmartHandle – SC, warnings differ depending on whether a
transponder or a SmartCard is used.
SmartHandle (Manual)
12. Battery warning (manual)
108 / 136

Table of Contents