10. Using the installation tool, push the slider on the inside of the inlay back
to the home position.
IMPORTANT
Installation difficulties due to sliders
If you do not fully slide the slider to the home position, you will not be able
to lock the inner cover.
Push the slider completely to the home position!
11. Reapply the inner cover until it is flush with the door.
12. Reapply the inlay.
9 The inlay snaps back into place noticeably.
9 The batteries have been replaced.
13.4 G2 battery replacement ID medium
A G2 battery replacement ID medium (transponder or smart card) is
needed to eliminate freeze mode in a G2 locking device. This mode should
never occur due to the integrated battery warning system; batteries are
SmartHandle (Manual)
13. Battery replacement
121 / 136
To Next Page
Loading...