9 Every bar corresponds to a position. The first bar corresponds to the
unauthorized position zero. The illustration depicts the cone at
position 1.
5. Turn the ring segment back to the original position until you hear it aud-
ibly snap back into position.
Determining the installation direction
The door lock must be in the unbolted position when it is installed.
The square opening in the bolt sensor must always point to the right
towards the door hinges when the bolt sensor is fitted. This determines
whether the bolt sensor needs to be fitted from the inner or outer side of
the door.
Fitting the bolt sensor from the inner side
1. Carefully release cable from the bolt sensor cable duct (C) to guide the
plug out onto the inner side.
2. Push the bolt sensor into the profile cylinder opening via the installation
tool (D) until it stops.
9 The square opening in the bolt sensor must always point to the right
towards the door hinges.
3. Rotate bolt sensor 90º, so that the bolt sensor opening points down-
wards.
4. Pull the installation tool to remove.
9 The bolt sensor remains in the lock. The rectangular opening in the
bolt sensor faces downwards.
Fitting the bolt sensor from the outer side
1. Push the bolt sensor (B) into the profile cylinder opening via the install-
ation tool (D) until it stops.
9 The square opening in the bolt sensor must always point to the right
towards the door hinges.
2. Rotate bolt sensor 90º, so that the bolt sensor opening points down-
wards.
3. Pull the installation tool to remove.
9 The bolt sensor remains in the lock. The rectangular opening in the
bolt sensor faces downwards.
Fix anti-twist mechanism in the door lock
Introduce the anti-twist mechanism (E) in the rectangular opening of
the bolt sensor until you hear it snap into position. If necessary, the anti-
twist mechanism can be slightly pressed together so that it fits through
the lock better.
SmartHandle (Manual)
7. Installation (manual)
71 / 136
To Next Page
Loading...