To Next PageTo Next Page
Need help?Do you have a question about the Simple Motors Kit 9 and is the answer not in the manual?
Insert the T-pin into a cap and then the rotor core into the same cap.
Insert the wooden insert and the pushpin into the other cap, then push caps together.
Glue magnets to the rotor core and attach the disk with sequins to the cap.
Insert rotor into stands and glue the stands to the board, checking for free spin.
Identify opto-interrupter pins, bend and solder resistors.
Attach felt pad and mount the reed switch on its stand, ensuring correct positioning.
Bend Hall Effect switch leads, solder wires, and insert into the universal stand.
Locate transistor leads, bend, and solder to the switch bracket.
Attach the battery holder and prepare wires by marking and routing.
Connect all wires to the switch, ensuring correct connections before soldering.
Tighten the switch knob, add washers, and install the dial.
Align the knob with 'R' and tighten the set screw for final operation.
Provides the complete electrical schematic for Kit #9.
General| Brand | Simple Motors |
|---|---|
| Model | Kit 9 |
| Category | Engine |
| Language | English |
