EXAMPLE:
An SCC with Transponder number 6
CONTROLLER-
BOARD
BACK BOX +-
- On switch package S2, OPEN switches 1 and 3 to indicate
address of 5.
Since one transponder address can only handle 64 SCC switches or 256 SCC points, and one controller board
can only handle two transponder addresses, it is often necessary to assign more than one address to an SCC.
The required transponder addresses will be designated in a block on the bottom right-hand corner of your Status
Command Center equipment order sheet. In the following examples you will see how we set the SCC switches
on switch package S2 for SCCs with multiple addresses.
EXAMPLE 1.
Given an SCC with Transponder numbers 6 and 7:
And one controller board
And two controller boards
’ n--~~~~~~~
EXAMPLE 2.
Given an SCC with Trahsponder numbers 6,7, and 8 (SCC must have TWO controller boards):
If less than 64 switches assigned
If more than 64 switches assigned
to the first controller:
to the first controller:
I
I
to indicate address 5
I
On switch package S2
0
open switches 2 and 3
to indicate address 6
EXAMPLE 3.
Given an SCC with Transponder number 6,7, 8, and 9 (SCC must have TWO controller boards):
On switch package S2 open switches 1 and 3 to indicate address 5.
On switch package S2 open switches 1,2 and.3 to indicate address 7.
36
To Next Page
Loading...