Simplex 4005 - Page 38

3-20
Points can be viewed and Disabled/Enabled by following the steps shown in
Table 3-5.
Table 3-5. Viewing and Disabling/Enabling a Point
Step Action LCD Display
1.
Log In to the 4005 at Access Level 2, 3, or 4.
2.
From the High-Level Status display, press <
Menu>.
3.
Press <ó
Next> or < Previous> to scroll through
the menu until [
View Point] is displayed and then
press <
Enter>.
4.
Press <ó
Next> or < Previous> to select the
desired point type and then press <
Enter>.
5.
Press <ó
Next> or < Previous> to select the
desired point and then press <
Disable/Enable>.
6.
Press <ó
Next> or < Previous> to scroll from
Enable to Disable and then press <
Enter>.
7.
Press <
Enter> again to confirm your choice.
IMPORTANT: Refer to the warnings at the beginning of this manual
before using the Disable function.
Choosing Disable removes positive voltage from the
zone. Choosing Enable provides a 30-second countdown
before a point enables.
Control / View Points, Continued
Disable/Enable a Point
6<67(0,61250$/

SP7XH -XO
6<67(0,61250$/

0HQX>9LHZ3RLQW@
6<67(0,61250$/

9LHZ3RLQW>0RQLWRU@
&ODVVURRP
 7UDLQLQJ&HQWHU
0RQLWRU=21( 1250$/ 
&ODVVURRP
 7UDLQLQJ&HQWHU
&RQWURO>(QDEOH@ 6WDWXV (QDEOHG
Technical Manuals Online! - http://www.tech-man.com