Display will read:
If you are not correcting secondary clocks, you can set the mode to 0. In this mode all outputs are available for
timed events. Simply press [ENTER] to select mode 0, and the master clock will advance to the next Auto
Prompt display. To select a specific mode, press any key except [ENTER] or [EXIT]. This will advance the
display through the secondary clock modes. Once the desired secondary clock name and model number is
displayed, press [ENTER] to select that model. For the Simplex 59
th
minute correction, the display will be:
After pressing [ENTER] the master clock will advance to the next Auto Prompt display. Please note that relays 3
and 4 are dedicated to secondary clock correction and will no longer be available for timed events. A complete
list of clock correction modes supported by the Simplex 6500 will be found in the “Clock Modes Supported” table
at the end of this guide. For information on secondary clock modes not described in this guide, please contact
JCI Global Fire Detection Technical Support.
4.10 BASIC Program
The next entry of the AUTO-PROMPT sequence is basic programming. Refer to Section 6.0 PROGRAMMING
for details on entering your basic program.
Note: Setting Annuals is not included in the auto prompt sequence. See ENTERING, REVIEWING OR EDITING
THE ANNUAL PROGRAM (Section 6.3).
13
To Next Page
Loading...
Need help?
General
