5.4 REVIEWING OR EDITING THE DAY [4] [ENTER]
You must be in the time display. Press the DAY key [4]. The display will respond with:
Press [ENTER]. The display will respond with:
The day of the week may now be entered in the same manner as in the AUTO-PROMPT sequence. (Section
4.5)
5.4 REVIEWING OR EDITING DAYLIGHT SAVINGS TIME [7] [ENTER]
You must be in the time display. Press the DST key [7]. The display will respond with:
Press [ENTER]. If daylight savings time not previously set, the display will respond with the default entries for
the current U.S. law as follows:
You may now enter the new daylight savings time settings as outlined in Section 4.6.
5.5 REVIEWING OR EDITING THE RELAY PULSE (MOMENTARY OUTPUTS)
FOR RELAYS 1,3,4,5,6,7,8 [5] [ENTER]
The pulse is for applications in which only a momentary contact is required (i.e. ringing bells). See Section 4.7
for more information on pulse settings. Start from the time display. Press key [5]. The display will respond with:
Press [ENTER]. The display will respond with:
The pulse settings for relays 1,3,4,5,6,7 and 8 may now be set as outlined in Section 4.7.
15
To Next Page
Loading...
Need help?
General
