7 - 61
7 Transmission Repair
7E Tuff Torq K210A
8. Remove two capscrews holding torque strap to case
on front right of transaxle.
NOTE: Shift linkage pivot assembly may be left attached
to torque strap when removing transaxle.
9. Remove the jam nut from the left rear transaxle
mounting bolt holding the shift interlock return spring
in place.
10. Place floor jack under center of transaxle housing.
11. Remove four nuts from capscrews holding transaxle
to frame.
12. Carefully lower the transaxle to the ground making
sure the mounting straps and linkages clear the
frame.
To reinstall, follow the removal procedure in reverse
order.
Figure E-6. Remove Transaxle Mounting Hardware
Disassembly
1. Drain the transaxle oil if not done already.
Drain Plug
Figure E-7. Transaxle Oil Drain
2. Remove E-Clip from input shaft on top of the input
shaft pulley and remove the pulley.
Figure E-8. Remove Input Shaft Pulley
To Next Page
Loading...