Simplicity Broadmoor 5008 - STARTING AFTER STORAGE

taken to insure the tractor will be ready to go when you
need it.
1. Drain the fuel tank completely by running the tractor
until it stops. This may be easily done by removing the gas
line at the carburetor and draining the tank thru this hose.
If you desire, fuel may be stored in the tank or a small
container if a good brand of gasoline stabilizer is used. This
additive, available from your dealer, prevents formation of
gum and varnish for up to one year, providing easier start¬
ing and a clean fuel system.
2. Drain and refill the crankcase when the engine is warm.
See "Maintenance".
3. Remove spark plug, pour one ounce of 10W-30 oil into
cylinder through plug hole. Crank engine a few times to
distribute oil and reinstall the plug.
6. Block the machine up off the wheels to relieve weight
and keep tires off a damp floor. Protect the tires from
prolonged exposure to direct sunlight.
7. Store the machine in a dry place indoors.
STARTING AFTER STORAGE
1. Remove the spark plug and wipe dry. Crank the engine a
few times to blow the excess oil out of the plug hole.
Reinstall the plug.
2. Fill the fuel tank with fresh "regular" gasoline (unless a
fuel stabilizer has been used).
3. Service the air cleaner. See "Maintenance".
4. Check the crankcase oil level and replenish if necessary.
See "Maintenance".
4. Clean dirt and chaff from cylinder head fins and engine
housing.
5, Grease all zerks and apply oil to all points shown in
"Maintenance".
5. Start the engine outdoors or in a well ventilated area. Do
not run the engine at high speed immediately after starting.
6. Inflate the front tires to 12-15 P.S.I., and rear to 6-8
P.S.I.