17
SimpliFire • SF-OD43, SF-OD55 • 2047-980 Rev. C • 5/23
B. Operating by Remote Control
• The appliance Main Power button must be in the “ON”
position for the remote control to function.
• Make sure batteries are properly installed in Remote
Control.
- Battery requirements 2 x AAA batteries
(included).
• The effective range of the remote is up to 16 ft.
• The remote control must be within the 16 ft. range and
also be pointed directly at the face of the appliance.
For best results, point the remote control toward the
remote receiver location. See Figure 5.1.
ICON TITLE FUNCTION REMOTE
LCD DISPLAY
FIREPLACE
RESPONSE
POWER
The POWER button will turn the
replace on. It will also put the
replace in a standby mode.
This will turn off all functions at
once but will hold the settings in
memory except Timer function.
The appliance will turn on at the
same settings by pressing the
power button again.
LCD illuminates
and displays ame
status Icon and
temperature set
point.
Fireplace emits single audible
beep to conrm command to
transition to ON or STANDBY
state.
FLAME
By pressing the FLAME button,
the appliance will cycle through
four ame effects.
LCD illuminates
and displays ame
status icon.
Fireplace emits single audible
beep to conrm command to
transition between four FLAME
states.
FUEL BED
Pressing the Light button changes
the ember bed colors (14 color
themes available - 13 colors and
a color rotating option), and turns
it on/off.
No indicator.
BRIGHTNESS
Pressing the brightness button
toggles 4 brightness settings.
This adjusts all Lighting, Accent/
Flame/Fuel Bed brightness levels
simultaneously.
No Indicator.
TIMER
Pressing the Timer button sets
the time desired for the replace
to run. The Timer can be set from
.5 hour up to nine (9) hours in one
(1) hour increments.
Remote will
display the time
setting selected. If
in Stand-by mode
time will display
but cannot be
adjusted.
This remote control is not outdoor rated and
should be stored indoors and away from the
elements when not in use.
To Next Page
Loading...