9
SimpliFire • SF-OD43, SF-OD55 • 2047-980 Rev. C • 5/23
D. Location
Note: The Forum appliance is designed for indoor/out-
door use. The appliance is weather resistant and must
be installed in a framed wall. The appliance is equipped
with a GFCI power cord or can be hardwired.
When choosing a location for your replace ensure that
the following general rules are followed:
• The Forum replace is designed to work best when
ambient light levels are low. If the Forum is installed
in brightly lit areas or in direct sunlight, the strong
reections may diminish the ame. For best results,
install out of direct sunlight.
• Power supply service must be installed within
proximity of electric replace prior to nishing to
avoid reconstruction.
• See Figure 3.2 to determine location of appliance
installation.
E. Clearance to Combustibles
See Section 4.A for framing dimensions.
Minimum Clearance to Combustible Construction
Sides.......................0 in.
Floor........................0 in.
Top..........................0 in.
Back........................0 in.
Front........................0 in.
Mantel.....................0 in.
Mantel Depth..........Unlimited.
See Figure 3.2.
F. Electrical Supply Circuit Requirements
Plan the location of the appliance so that it will have ad-
equate electric power. A minimum 15 AMP, 120V/60Hz
circuit is required.
If hardwiring for an outdoor appliance, the circuit must
be Ground Fault Circuit Interrupter (GFCI) Protected.
Figure 3.2 Location and Clearances Requirements
To Next Page
Loading...