SimpliFire • SF-OD43, SF-OD55 • 2047-980 Rev. C • 5/23
18
A. Maintenance
WARNING! Risk of Shock! Always remove power before
moving or servicing. Do not immerse appliance in water.
• Before cleaning or servicing, always turn off appli-
ance and remove power, by either unplugging from
the wall outlet or shutting off circuit breaker.
• Light accumulated dust may be removed from the ap-
pliance exterior with a soft cloth or vacuum cleaner.
• Wipe the exterior surfaces of the appliance occasion-
ally with a slightly damp micro fiber cloth using a so-
lution of mild detergent and water. Dry thoroughly
before operating the appliance.
• The rotisserie motor is factory lubricated for life and
will not require further lubrication.
WARNING! Risk of Fire! To reduce risk of re, do not
store or use gasoline or any other ammable vapors or
liquids in the vicinity of the appliance.
WARNING! Risk of Electrical Shock! Any other servic-
ing needed must be performed by an authorized service
technician. Do not attempt to service the appliance your-
self.
B. Cleaning
CAUTION! Do not power wash or allow water to run into
the interior of the appliance as this could create a re or
electric shock. Always remove power before moving or
servicing.
Glass
Dust particles can be removed by bufng lightly with a
clean dry cloth. Fingerprints and other marks can be
cleaned with a cloth dampened with a quality household
glass cleaner. The glass should be completely dried with
a lint free cloth or paper towel. Do not use abrasive clean-
ers on glass surface.
Metal Surface
Dust particles can be removed by bufng lightly with a
clean dry cloth. A damp cloth can be used to clean paint-
ed surfaces. Do not use abrasive cleaners or chemical
household cleaners. Do not spray liquids directly on to
any surface.
6 6
MAINTENANCE
C. Servicing
Except for cleaning, an authorized service technician
should perform any other service.
Resetting Appliance GFCI Cord
If the Appliance GFCI power cord is tripped and there is
no power to the appliance, it must be reset by pressing
the “RESET” button on the GFCI plug. See Figure 6.1.
GLASS AND GLASS GASKET
It is normal during temperature changes for condensation
to form on the appliance viewing glass. This may require
the glass to be occasionally removed for cleaning the
interior side of the glass. See section 4.B for glass remov-
al instructions and refer to section 6.B for a suggested
cleaning method.
While removing and replacing the front viewing glass,
caution should be taken to ensure the glass gasket re-
mains in place on the appliance.
Before re-installing the front viewing glass, ensure the
glass gasket is fully seated and not blocking the bottom
glass channel. If the gasket is protruding into the channel
the glass may not fully seat and could cause interference
when re-installing the glass.
If the glass gasket becomes separated from the appliance
gasket channel it must be reinstalled by pressing the gas-
ket back into the glass gasket channel of the appliance. If
the gasket is damaged or becomes unusable contact your
dealer for a replacement.
WARNING! Risk of Electrical Shock! Do Not Open! No
user serviceable parts inside. Always turn appliance off
and disconnect power before performing maintenance,
service, or removal from the framed wall opening.
Figure 6.1
To Next Page
Loading...