Starting your washing machine
6 Simpson Starting your Washing Machine
If the settings shown on the control panel are what you want
to use and the Program SELECTOR is set to the correct wash
program for your clothes load, press the START/PAUSE button
to start your wash. To select a different program or change other
settings, read the following instructions
Choose the wash program
Turn the Program SELECTOR knob to choose the wash program
you want.
The table “YOUR Program GUIDE” shown below will help you in
selecting the right program.
The Program Selector knob is not a timer.
Once you select a wash program, the Program Selector knob will
stay at that position for the whole of the wash.
Select this program
Temp
Heavy Duty* for a heavily soiled cotton wash load. Hot or Warm Extra Dirty Eco or Deep
Normal / Heavy for a full load of normally soiled cottons. Hot or Warm Regular Eco or Deep
Normal for an average domestic load of mixed fabrics.
Hot, Warm or
Cold
Regular Eco or Deep
Colours
for an average load of coloured fabrics. DO NOT
include whites or any other items you want to
keep true to their colour.
Warm or Cold Regular Eco or Deep
Delicates for lingerie, lace, trimmed and embroidered items. Warm
Regular or Light
& Fast
Eco or Deep
Woollens for woollen fabrics labelled 'Machine Washable'. Warm
Regular or Light
& Fast
Deep
Drip Dry
for items that are to be taken out of the washing
machine dripping wet.
Warm
Regular or Light
& Fast
Deep
Rinse + Spin
for items that you want to rinse and spin eg clothes
items you have hand washed in a wash tub.
– – Eco or Deep
Drain + Spin** for very wet clothes to remove the water – – –
*Heavy Duty has a built-in Soak period of 6 minutes
**Drain + Spin has a built-in pump out period of approx. 5 minutes prior to spin. (See “Choose the wash program” above.)
***Deep uses more water than Eco to rinse clothes. (See pages 3 and 10)
You can turn the Program Selector knob to a new program
position at any time.
If you do move the Program Selector knob after you have started
a wash program, the effect will be different depending on the
status of the machine at the time, as follows:
1. When the machine is running, moving the knob to a new
position will result in the machine continuing to wash but the
behaviour of the remainder of the wash changes to match the
new program setting.
2. If you pause the machine, moving the knob to a new position
will result in the machine resetting to the start of the new
program.
NOTES:
• When you choose the WOOLLENS or DRIP DRY program, the DEEP
RINSE option is automatically selected for you. You will not be able to
select and use Eco Rinse with these two programs.
• When you select the DRAIN + SPIN program, there will be a delay
of approximately 5 minutes before the washing machine starts to
spin. This delay is a DRAIN and pump out period to ensure the bowl
is empty of water, which is necessary before spin commences. During
this time the drain pump will cycle ‘ON’ and ‘OFF’ to allow water to
move from the washbowl to the outer bowl. Even though you may
have only put wet clothes into an empty bowl, the delay before spin
will still occur to be safe and to protect your washing machine.
To Next Page
Loading...
