Simpson Washing Instructions / Starting your Washing Machine 5
1. low sudsing front load washer detergent
“Matic”.
measuring out the amount recommended on the package.
2. Mix detergent in one litre of hot or warm water.
3. Add the pre-mixed detergent to the wash load.
Detergent use:
a front load washer detergent in this machine
such as Cold Power for Front Loaders and High Efficiency Top
Loaders or detergents labelled “Matic”.
the wrong type of detergent.
too much detergent. This will give you too many
suds causing low spin speeds, poor rinsing and overloading the
motor during spin stages of the wash program.
too little detergent because you will get a poor
wash. If you think you need more, increase dosages by only small
amounts to avoid excessive suds.
soap based products in your washing machine.
1. Measure the correct amount of fabric softener by following
the recommendations on the package.
2. Mix softener with an equal amount of warm water but only
mix enough to fill to the line marked inside the cup.
The softener cup holds 75ml.
3. Pour the mixed softener into the cup in the top of the agitator.
Do not overfill the cup.
4. Do not spill fabric softener on the clothes as it may stain them.
If you are going to use fabric softener, you must select the DEEP
RINSE option, ie deselect the ECO RINSE option. See ‘Rinse
options’ page 10.
NOTE: You do not have to use fabric softener, your washing machine
will wash the clothes perfectly well without it.
Bleachingofclothescanhelptoremovestains,heavysoilingand
to kill bacteria.
This is generally a powder type bleach.
Mix the required quantity with water and pour down the bleach
hole in the top panel during the fill when there is some water in
the washbowl. Refer to the instructions on the bleach container.
Chlorine type - This type of bleach should not be mixed with
detergent. Mix the bleach with water as per the instructions
on the container. Turn Program SELECTOR to a wash program
position and press the START/PAUSE button to commence
water fill.
Pour the bleach solution down the bleach hole in the top panel
during fill when there is some water in the washbowl. Allow the
machine to agitate for a few minutes, then let it stand for
the required time by pressing the START/PAUSE button.
Turn Program SELECTOR to Drain + Spin position and press the
START/PAUSE button to empty the washbowl.
You can now wash the clothes load using detergent and your
selected wash program.
NOTE: Bleach should not be used on silk, wool, rayon or drip dry clothes.
Starting your washing machine
1. Turn on the taps
2. Close the lid
3. Press the POWER button
The machine will ‘beep’ twice and show a pattern of lights. Wait
for this to happen before attempting to operate the machine.
Your washing machine is now ready for you to select the wash
program settings.
To Next Page
Loading...
