SimPure HP8 - Operational Guide; Control Panel and Functions; Filter Reset Procedure

Operational Guide
Control Panel
Power Button
Press the Power button to turn the air purifier into
operational mode.
Press
the power button a second time to stop the
air purifier and place it into standby mode.
Fan Speed
Repeatedly pressing the fan speed button after
power-on will cycle through the fan speeds:
Sleep
– Low speed
2
– Medium speed
3
– High Speed
The
corresponding wind speed indicator light will
display the current fan speed.
Sleep mode
Press the sleep button after power-on, and the
air purifier enters the quieter sleep mode.
All indicators lights are off; only the sleep mode
light is on (low fan speed).
Timer
Press the timer button after power-on to set the
timed auto-off feature.
Repeatedly press the timer button to cycle
through the auto-off times 1, 2, or 4 hours; the
corresponding indicator light will display the
auto-off time setting selected.
Filter Reset
When the air purifier's total run hours reach
1,500 hours, the indicator will flash as a
reminder to replace the filter. After the
replacement is completed (see page 9), you need
to press and hold the filter button for 3 seconds
until the indicator light is off; the filter timer
function is now reset.
Warning:
It is only possible to reset the filter lifespan when the Filter light is
flashing.
7
8