| 5
Introduction | FU80, NF80, QS80 User Guide
Introduction
About this manual
This manual describes how to install and use the FU80, NF80 and
the QS80 remotes.
NF80 FU80 QS80
These remotes can be used to remotely control the AP70, AP80,
AP24, AP28 and AP60 autopilot systems. They can also be used
to remotely operate the autopilot function in NSE, NSS and NSO
(Simrad Multifunction Displays).
¼ Note: It is not possible to use FU80 with an AP24/28 operating on
VRF (Virtual Rudder Feedback).
For detailed description of operational modes, see the Operator
manual for your autopilot system or for your NSE/NSO/NSS.
For details about installation of CAN bus or SimNet backbone, see
the autopilot System Installation manual.
Wheelmark approval
The remotes are produced and tested in accordance with the
European Marine Equipment Directive 96/98 and can be used in a
Wheelmark installation according to the certificates.
For details and certificates refer to our websites:
pro.simrad-yachting.com and www.simrad-yachting.com.
11
To Next Page
Loading...
Need help?
General
