| 47
Navigating with the MX610/MX612 | MX610/MX612 Operator and Installation Manual
Navigation Panels
The Steer and Position panels are used to display information when you are navigating.
NAV Panel
NAV
Data
Heading
Status Bar
Destination
WPT#
Cross-Track
Limit
Course Line
Vessel
Data Fields
The NAV/Steer panel offers the following information:
Heading True or magnetic compass heading
Status Bar Shows condition of GPS, RAIM and alarm
WPT#/Name Destination waypoint identification
DTD Distance to destination
BTW Bearing to waypoint
SOG Speed over ground
COG Course over ground
TTD Time to destination
ETW Estimated time of arrival at next waypoint
STEER Course to steer towards next waypoint
Course Line
When travelling on a route the course line shows the intended course from one waypoint
towards the next.
When navigating towards a waypoint (MOB or an entered Lat/Long position), the course line
will show the intended course from the point at which navigation was started towards the next
waypoint.
Vessel Symbol
The vessel symbol indicates distance and bearing relative to the intended course.
O course Limit
If the XTE exceeds the defined off course limit, this will be indicated with a red arrow including
the distance from the track line.
If the off course alarm is enabled, and the XTE exceeds the defined off course limit., the alarm
will activate.
To Next Page
Loading...
