56 |
Alarm system | MX610/MX612 Operator and Installation Manual
Acknowledging a message
The following options are available in the alarm dialog for acknowledging a message:
Option Result
Close
(or OK)
Sets the alarm state to acknowledged, meaning that you are aware of the alarm
condition. The siren / buzzer will stop and the alarm dialog will be removed.
The alarm will however remain active in the alarm listing until the reason for
the alarm has been removed.
Disable Disables the current alarm setting. The alarm will not show again unless you
turn it back on in the Alarms dialog.
There is no time-out on the alarm message or siren. These remain until you acknowledge it
by pressing the ENT key or the center of the rotary knob or until the reason for the alarm is
removed.
Alarms dialog
The alarms can be setup in the Alarms dialog. This dialog also includes information about ac-
tive alarms and alarm history.
Alarm Settings
To setup the alarm limits, press the PAGE key to change the tab to Settings. Use the rotary
knob to scroll up or down through the different alarm settings and press the ENT key to affix
the check mark and specify limit values.
To Next Page
Loading...
