No. Key Description
1
PAGE key: Brings up different screen page every time this key is pressed or to
change tab in the settings and tools menu.
2
MENU key: Brings up the quick menu dialog box.
3
PWR/LIGHT key
Short press - to turn ON the unit.
Momentary press brings up the backlight and night view controls.
Series of short presses will cycle through 6 levels of display brilliance.
Long Press - to turn power off.
4
ROTARY KNOB: Rotate to scroll through menu list, icons, alphabets or numbers
in the virtual keypad and zoom-in or out in the PLOT mode. Press the center of the
knob to select menu item or accept entry. The same entry action when you press
the ENT key.
5
CLR key: Press to clear, escape or back out of the menu or data entry.
6
ENT key: Press to accept menu selection or data entry. The same action as pressing
the center of the rotary knob.
7
MOB key: Short press will save the present position L/L into the next vacant
waypoint. Press and hold for 3 seconds activates the Man-Over-Board (MOB)
function.
8
POS key: Hot key to display the present position Latitude, Longitude, COG, SOG,
Date and Time. Press repeatedly to show POS1, POS2 or POS3 screens.
9
NAV key: Hot key to display the navigation information. Press repeatedly to show
NAV1, NAV2 or NAV3 screens.
10
HDG key: Hot key to show the compass rose, Pitch, ROT and Yaw information
coming from a gyro or a GPS compass. Press repeatedly to show HDG1 or HDG2
screens
11
AIS key: Hot key to display the PLOT screen showing your vessel, waypoints, route
and other navigation information. Will show AIS targets when connected to an AIS
receiver via the NMEA 2000 network.
12
USB door: To open, lift the right tab and slide the cover to the right. To close, slide
cover to left and push the tab down. Close USB door at all times to prevent moisture
intrusion. (MX610 and MX612 only)
13 USB key: Press to display the files contained in the USB memory stick.
14 USB Connector
1
To Next Page
Loading...
