Need help?Do you have a question about the Simrad NAC-D and is the answer not in the manual?
General| Type | Autopilot System |
|---|---|
| Max Current Output | 10 A |
| Communication | NMEA 2000 |
| Water resistance | IPX6 |
| Operating Voltage | 12/24V DC |
| Maximum drive output (continuous) | 10 A |
| Operating Temperature | -15°C to +55°C |
Legal notice regarding product use and liability.
Specifies the official language version of the documentation.
Lists registered trademarks and intellectual property rights.
States copyright holder and warranty information for the product.
Declares conformity with regulatory requirements for different regions.
Details about the manual's scope, text conventions, and available translations.
Overview of the NAC-D autopilot computer and its system compatibility.
Discusses control units, user interface, and available autopilot steering modes.
Outlines the two main steps for configuring the autopilot computer after installation.
Process for selecting and configuring necessary data sources for the autopilot system.
Explains the SteadySteer feature's reaction to manual steering inputs.
Covers settings like boat type, length, and cruising speed affecting autopilot performance.
Controls how the autopilot computer operates the boat's steering system.
Guides on choosing the correct rudder feedback source for the autopilot.
Instructions for calibrating the compass for optimal autopilot performance.
Defines the speed at which the autopilot switches between low and high speed profiles.
Used for setting the preferred turn rate of the boat.
Procedures for verifying and optimizing autopilot steering performance.
Explains the parameter determining the ratio between commanded rudder and heading error.
Describes the opposite rudder applied to stop turns after course changes.
Configuration options for High and Low speed steering profiles.
Manually setting the turn rate for heading changes greater than 5 degrees.
Controls how fast the autopilot applies rudder to compensate for heading offset.
Defines how the rudder moves when switching to automatic mode from manual steering.
Configuration for automatic turn steering features available in AUTO mode.
Enables the autopilot to follow a depth contour.
A list to verify the correct installation of all autopilot system components.
Details for recording boat-specific configuration parameters.
Overview of steering system settings and profiles.
Settings for low and high speed steering profiles.
Limited maintenance tasks required for the unit.
Instructions for visual inspection of unit connectors.
Procedures for updating the autopilot computer software.
How to reset the autopilot to its factory default settings.
To Next Page
