Drive configuration
The drive configuration controls how the autopilot computer
operates the steering system.
Refer to your drive unit documentation for relevant specifications.
Minimum rudder
Some boats may have a tendency to not respond to small rudder
commands around the “course keeping” position because of a small
rudder, whirls/disturbance of the water-stream passing the rudder,
or it is a single nozzle water jet boat. By increasing the Minimum
rudder parameter you may improve the course keeping
performance on some boats. However, this will increase the rudder
activity.
Ú
Note: Only set a value for minimum rudder if it proves to give a
better course keeping performance in calm sea. It should be set
after the autopilot steering parameters have been optimised/
tuned.
14
Dockside setup | NAC™ -D Commissioning manual
To Next Page
Loading...
Need help?
General
