M
ultiFlame DF-TV7 Page 26 / 56 NOSP16358-03 [04/2016]
4.3.8. Syntel connection
In this network version, an electronic board is inserted in the detector body and is used for
electric connection.
Connecting the ground terminal should be performed thanks to 3-wire shielded cables.
The connection of power supply wires (4 on side A and 4 on side B).
• Two red wires on V +: +24 V
• Two white wires on V-: 0 V
Connexion of the media wires (2 on side A and 2 on side B)
• A red wire on one of the N
• A white wire on the other N (no specific edge)
Figure 5 : Connecting drawing of the network versions
For more detail, thanks to refer to the operating manual NOSP 15251
To Next Page
Loading...