Simtronics MultiFlame DF-TV7-T - 5. Commissioning; 5.1. Visual inspection; 5.2. Power-up; 5.3. Operational tests

To Next Page

To Previous Page

ultiFlame DF-TV7 Page 29 / 56 NOSP16358-03 [04/2016]

5. COMMISSIONING

5.1. Visual inspection

Make certain that all the operations of the “Installation” chapter have been achieved

correctly.

Pay particular attention on installation conformity, check the cables entry, the presence of O-

rings, and the connexion of the cartridge.

• Check if the detection mode (UV/IR, 3IR) match with the marking

5.2. Power-up

The sensor is powered and operating when the green LED on the communication head is

flashing.

• Check the connection to the control unit

5.3. Operational tests

All MultiFlame detectors are delivered set and tested. Some additional tests are necessary

to check the good working of the loop. Please make sure to have all authorizations needed

before running the following operations:

• Check the states/information using the wireless configuration tool (TLU)

• Check alarms delay setting : (factory settings)

• 5 seconds for XT versions

• 2 seconds for XV versions

• Eventually, adjut the value up to 20 sec

The alarm state needs the fire detection to be continuously detected over the

full temporisation delay to be activated

SENSITIVITY SETTING

• Factory settings :

• 100%

• Except for XTB0 version (high sensitivity) 75%

• Eventually adjust the sensitivity between 50% / 75% and 100ù of the maximum

coverage distance

• Test the channel by trigging an alarm using the LT15 test lamp or force the output to

20mA via the TLU600.