M
ultiFlame DF-TV7 Page 44 / 56 NOSP16358-03 [04/2016]
9. WARNINGS
This document is not contractual. The product characteristics may be modified without prior
notice for improvement purposes or for upgrading to meet applicable standards.
9.1. Safety
These devices are certified to be used in hazardous areas. Install and use the detectors in
accordance with local and national regulations.
The detector must be properly grounded for protection against electric shocks and minimize
el
ectrical interferences.
The detector must be installed and handled only by qualified personnel.
There is no part that can be changed or repaired by the user. Calibration is done at the
factory, it must be checked periodically. Return the product to the factory for any
maintenance or repair outside the scope of calibration.
9.2. Ownership and confidentiality
The information, design data, drawings and diagrams contained in this document remain the
property of SIMTRONICS and are confidential.
The information contained in this document cannot be used, either partially or wholly, nor
divulged or reproduced without the prior agreement of SIMTRONICS.
10. WARRANTY
DF-TV7 are warranted 2 years. Application of the equipment warranty is subject to
compliance with the best practices and the operating instructions contained in this manual.
The SIMTRONICS warranty shall not apply; furthermore SIMTRONICS declines all liability, for
damage to equipment or harmful accidents caused by negligence, failure to supervise the
equipment or failure to use the equipment in compliance with the applicable
recommendations, standards and regulations stipulated in the present manual.
The SIMTRONICS warranty shall not apply to faults resulting either, from materials supplied
by the Purchaser, from design imposed by the Purchaser, from servicing or maintenance
carried out on SIMTRONICS equipment by a third party not explicitly authorized, or from the
use of unsuitable storage conditions.
In order to guarantee correct operation of the system, any addition of equipment to the
system or any modification of the installation must be validated by SIMTRONICS.
To Next Page
Loading...