Sindoh M611 - Page 177

171
below.
a) In case the tailing edge of the original goes into right before the 2nd Pickup
roller(A5~Legal)
-Open ADF top cover.
-Pull the tailing edge of the original slowly to the right to remove.
-Close ADF top cover.
b)In case the tailing edge of the original goes closly into the pressure
plate(A5~Legal)
-Open the whole ADF Unit.
-Open ADF bottom cover.
-Pull the tailing edge of the original slowyl to the right to remove.
-Close the whole ADF Unit.
c)In case the tailing edge of the original goes past the pressure plate(A5~Legal)
-Put your hand in the bottom side of the original guide, and remove the stuck in
paper to the right direction.
Pull the jammed paper softly and slowly not to be torn off. If possible, use your
both hands with uniform strength to remove the paper stuck in.
Pick up roller
Pickup
roller
2
nd
scan roller
Exit roller
2
nd
Pickup roller
1
st
Scan roller
Pressure plate
Exit idle roller
Origianl sensor actuator
Scan sensor actuator