Singer 3820 - Sewing on Buttons (for 2 Dial Model)

i--I Sewing on buttons (For 2 dial model)
Move the drop feed control to right side to lower the feed
dogs.
Change presser foot to button sewing foot (1).
Position the work under the foot. Place the button in the
desired position and lower the foot. Set the pattern selector
knob on ,_ and sew a few securing stitches. Select one of
the two narrow zig zag patterns according to the distance
between the two holes of the button. Turn the handwheel to
check if the needle goes into the right and the left hole of the
button without hitting the button.
Slowly sew on the button with about 10 stitches. Select
pattern _ and sew a few securing stitches (2).
If a shank is required, place a darning needle on top of the
button and sew (3). For buttons with 4 holes, sew through the
front two holes first (2), push the work forward and then sew
through the back two holes (3).
30
2
Button sewing foot