Singer 6233 - Changing the Presser Foot

Changing thePrcsserFoot
(B)
(E) (J)
(L)
Your machine comes
with the General Purpose
Presser Foot
already attached.
You
can easily
change to any one
of the other
presser
feet which
snap onto a common
shank by
following
the
directions below.
.
Raise needle
to its highest
position
by
turning hand
wheel toward
you.
.
Raise
presser
foot using
presser
foot
lifter
in
back ol
machine.
r
Push
toe of
presser
foot
(1)
up, until it
snaps otf
the
shank
(2).
.
Take foot otf machine.
.
Place new
foot
under center of shank.
r
Lower
presser
foot
lifter, fitting shank over
presser
fool
pin (3).
r
Don't turn
screw.
Instead,
push presser
foot screw
(4)
down
firmly until foot snaps
into
place.
o
Raise
needle and
presser
foot.
o
Open
slide
plate.
o
Slide
feed
cover
on
top of
needle
plate,
pressing
tabs
(1)
and
(2)
into
holes.
o
Close
slide
plate.
o
To remove, open slide
plate
and litt
front
edge of
cover;
pull
it away.
ATTACH,NC
FEED COVEN
G)
The feed
cover keeps the feed lrom
moving the
fabric.