Singer 6233 - Connecting and Running the Machine

Connecting the Machine
The solid state system
assures constant speed as
you
maintain the same
pressure
on the
controller
when
sewing
through
various fabric
thicknesses.
Unwind
the air control hose
from foot oper-
ated
speed controller.
Always be sure air
hose is
not
blocked.
Pressing on
the controller,
you
should
feel a
slight air flow
from
the
hose.
Plug this air
hose onto the
receptacle above
power
cord,
at the
right
end
of the machine.
Then connect the electrical
power
cord
plug
to
your
electrical outlet.
NOTE: When not using
the machine,
rewind air hose around speed
controller
for
storage. as shown.
Do
not
oDerate
machine
without
material
under
the
presser
foot as this may
damage
the
feed
and
the foot.
To turn on
machine and sewing
light, slide
power
switch
left
to
"1"
position,
To turn ofi
machine and
light, slide
power
switch
right
to
"0"
position.
To run the
machine,
press
the
speed
con'
troller.
The
harder
you
press,
the faster
the
machine
will sew.
To stop
the
machine from sewing,
remove
pressure
from speed
controller.
RunningtheMachine
The machine
and the sewing light are turned on and
otf by the same
power
switch.
1-
+-o