Singer 6233 - Bobbin Winding and Insertion

Winding a
Bobbin
Winding
a bobbin is
quick
and
easy
when
you
follow
the directions below.
Always
wind the
bobbin
before
threading
the machine.
r
Push
in indent
('l)
on hand
wheel disc,
This will stop the needle from
moving.
o
Place spool of
thread on spool
pin.
r
Slide spool cap
(2)
firmly over rim of spoolto
prevent
thread
tangling,
o
Lead thread from spool and snap
into
thread
guide
post (3).
o
Wind
thread clockwise
around front of bobbin
winder
tension
disc
(4).
.
Passthread end, from
inside, through
small
hole
in rim
of bobbin.
r
Place
bobbin
on spindle
and
push
it
to the
right.
r
Holding thread
end,
step on speed controller
to run machine until desired amount of
thread is wound.
(Winding
stops automatically once bobbin
isfull.)
o
Cut thread;
push
bobbin to the left and remove it from spindle.
o
Trim thread
end from top of bobbin.
.
Return hand wheel
disc to sewing
position
by
pressing
on side opposite
indent.
10