Singer 9340 - Lower Thread Management; Bringing Up Bobbin Thread; Thread Cutting

16
CUTTING THE THREAD
Raise the presser foot. Remove the fabric, draw
the threads to the left side of the face cover
and cut using the thread cutter.
The threads are cut at the proper length to
start the next seam.
1 Hold the upper thread with the left hand.
Turn the handwheel towards you
(counterclockwise) lowering, then raising the
needle.
2 Gently pull on the upper thread to bring the
bobbin thread up through the needle plate
hole. The bobbin thread will come up in a
loop.
3 Pull both threads to the back under the
presser foot.
1
2
3
DRAWING UP THE LOWER THREAD
2
3
1