60
BUTTONHOLE SEWING
This machine can sew 4 type buttonholes.
61. Bar-tack Buttonhole (Narrow) for light to
medium weight fabrics
62. Bar-tack Buttonhole (Wide) for large buttons
63. Keyhole Buttonhole for heavy weight fabrics
64. Keyhole Buttonhole with reinforced bar tack
Buttonhole Foot (with under plate)
Note:
Density of buttonhole legs may be adjusted with
stitch length control.
1. Mark position and length of buttonhole on
fabric.
3. Pass upper thread through the hole of
buttonhole foot and bring upper and bobbin
threads to the left.
4. Position fabric under presser foot so that the
center line mark is in the center of the
buttonhole foot.
Lower the foot.
Note:
When sewing stretch fabrics, it is suggested that
you use interfacing on the backside of the fabric.
5. Lower the buttonhole lever completely.
Note:
Machine will not start to sew if buttonhole lever is
not lowered properly or buttonhole foot is not
positioned correctly.
6. Hold upper thread lightly and start the machine.
2. Set button on the base.
If button does not fit on the base, adjust slide on
base to diameter of button plus thickness of
button.
a = Length of button + thickness
9910EFSt.pm6 2003.9.10, 8:47 PM60
To Next Page
Loading...
