Sinoboom GTJZ1412E - Physical Hazards

© Jun 2020 3-6 GTJZ1412E&1414E&1412E Plus Operation Manual
SAFETY
UNSAFE OPERATION HAZARDS
• Do not allow the platform to touch
nearby objects.
• Do not tie the platform onto near-
by objects.
• Do not put the load outside the
platform.
• When the platform is caught or
stuck or when other objects in the
vicinity impede its normal move-
ment, do not use the platform con-
troller to lower the platform. If you
intend to lower the platform with a
ground controller, you must oper-
ate it only after all personnel have
left the platform.
• Do not operate the machine when
the chassis door box is open.
• When one or more of the ma-
chine’s tires are off the ground,
evacuate all personnel before at-
tempting to stabilize the equip-
ment. Use a crane, forklift or other
suitable apparatus to stabilize the
equipment.
FALL HAZARDS
At a minimum, operators must operate and maintain the
machine as stated in this manual and in the Mainte-
nance Manual in addition to following more stringent in-
dustry regulations and workplace rules.
FALL HAZARDS
• Each person on the platform must
wear harnesses or use safety
equipment consistent with gov-
ernment regulations. Fasten the
cable to the fixed point of the plat-
form. Never fasten the cable of
more than one person to a fixed
point on the platform.
• Do not sit, stand or crawl on the
guardrails. When on the platform
always remain standing on the
platform floor.
• Do not climb down from the plat-
form when the platform is
elevated.
• Keep the platform floor free of
obstacles.
• Do not enter or exit the platform
unless the machine is fully in
place.
• Close the platform entrance door
before operating the machine.
• Do not operate the machine if the
handrails are not properly in-
stalled and the platform entry
door is not closed.
COLLISION HAZARDS
At a minimum, operators must operate and maintain the
machine as stated in this manual and in the Mainte-
nance Manual in addition to following more stringent in-
dustry regulations and workplace rules.