SAFETY
GTJZ1412E&1414E&1412E Plus Operation Manual 3-9 © Jun 2020
NOTICE
After charging the battery, be sure that:
• The battery cable connections are free of
corrosion.
• The battery hold-down and cable connections are
secured.
Adding terminal protection and anti-corrosion
sealants will help reduce corrosion of the battery
terminals and cables.
CHARGING THE BATTERY
• Do not expose the battery or charger to water or rain
during charging.
• Keep a charging battery away from direct sunlight.
• Always charge the battery using the charger
supplied by the manufacturer.
HANDLING THE BATTERY
• Only trained personnel with permission from the
workplace may remove a battery from a machine.
• Never force a battery during installation or removal.
Never drop a battery.
• Never short-circuit the outlet of the battery pack
directly with the wire.
• If battery acid spills, use water mixed with
bicarbonate (baking soda) to neutralize the acid.
• Do not store batteries in wet places or in water.
• Check the wire for damage daily. Replace any
damaged parts before operation.
WELDING AND POLISHING
REQUIREMENTS
Before welding, grinding and polishing operations, al-
ways ensure you read and understand all operation and
maintenance requirements in this manual and the Main-
tenance Manual.
WELDING HAZARDS
• Comply with the welder manufac-
turer’s recommendations for pro-
cedures concerning proper use of
the welder.
• Welding leads or cables may only
be connected after turning off the
power unit.
• Carry out welding operations only
after the welding cable has been
correctly connected.
• Do not use the machine as a
ground wire during welding
operation.
• At all times, make sure that the
power tools are completely stored
in the working platform. Do not
hang the power tools on the rail-
ing of the working platform or the
work area outside the working
platform, or hang the power tools
directly by the wire.
Before performing welding, grinding and polishing work,
welders must seek permission of the responsible de-
partment at the workplace.
AFTER USING THE
MACHINE
1. Choose a safe parking location that is on sturdy,
level ground and that is free of obstructions. Avoid
areas with heavy traffic.
2. Lower the platform.
3. Turn the emergency stop switch of the ground con-
troller to the “OFF” position
4. Turn the key switch to the “OFF” position and re-
move the key to avoid unauthorized use of the
machine.
5. Block the wheels with the wheel wedges.
6. Charge the battery.
NOTICE
After using the machine, the power off switch must
be disconnected.
To Next Page
Loading...
